Engineering Dictionary
"A" "B" "C", "D", "E", "F", "G", "H", "I", "J", "K", "L", "M",
"N", "O", "P", "Q", "R", "S", "T", "U", "V", "W", "X", "Y", "Z"

Resistor Terms:
'A', 'B', 'C', 'D/E', 'F-L', 'M', 'N', 'O', 'P', 'R', 'S', 'T', 'V-Z'

Resistor Networks:

Individual Resistors [Resistor Array]
Isolated Resistor Array. This package style [interconnect style] is used when there is no common connection point for the individual resistors.

Resistor Array connections used in SIP packages
Individual Connection Resistor Network

Individual Resistors, common connection
The resistor array shown above in one of three SIP packages. The individual resistors each have two nodes that only connect to the device, with no resistors connected to any other resistor in the package.
Common usage; Current limiters, Pull-up resistors or Pull-down resistors.




There are many possible common values for this style of resistor package. Use the table of values below to select a resistor.
This package orientation could be used to pull-up Unused Inputs on ICs, bring Tri-state outputs to a valid logic level, or to pull-up Open Collector outputs [wattage is a concern for OC outputs].

Resistor Values;

Value 22 27 33 39 47 56 68 82 100 120 150 180
220 270 330 390 470 560 680 820 1K 1.2K 1.5K 1.8K
2K 2.2K 2.7K 3.3K 3.9K 4.7K 5.6K 6.8K 8.2K 10K 12K 15K
18K 20K 22K 27K 33K 39K 47K 56K 68K 82K 100K 120K
150K 180K 220K 270K 330K 390K 470K 560K 680K 820K 1M --

Resistor Package Dimensions;

Physical dimensions of a 8-pin SIP package
8-pin SIP Component Dimensions

Related Components;
SIP Style; [Through-Hole]
Bused Resistor Network Schematic, SIP, Single In-Line Package.
Dual Termination Resistor Network Schematic, SIP Single InLine Pack
Nonstandard Resistor Network Schematic, 6-pin SIP

DIP Style; [Through-Hole]
Resistor Network Schematic, DIP, Dual In-Line Package.
RC Networks, DIP, Dual In-Line Package.

LLCC Style; [Surface Mount]
20-pin LLCC Network Schematics, Leadless Chip Carrier.
16-pin LLCC Network Schematics, Leadless Chip Carrier.
36-pin BGA Array Schematic, Ball Grid Array.

Physical dimensions of a 10-pin IC package
10-pin SIP Component Dimensions

Both an 8-pin SIP and 10-pin SIP are shown above, but a 6-pin SIP is not depicted. However a 6-pin Resistor SIP drawing is available on another page.

 
PC motherboard
Home

Distributor rolodex Electronic Components Electronic Equipment EDA CDROM Software Engineering Standards, BOB card Cabled Computer Bus Electronic Engineering Design Table Conversion DB9-to-DB25.
DistributorsComponents Equipment Software Standards Buses Design Reference