PS3



PS3 Pin out

Here are a few pin outs I saw out on one of the forums
I don't know if they are right or not, but on the next up-date I'll try and check them.
Note that I do not use or have every seen a PS3




PS3 connections.

Memory Card Reader (Ribbon bottom > up)

1 - AGND - Analog Ground
2 - DGND - Digital Ground
3 - AGND - Analog Ground
4 - Vcc - Input Voltage 5V
5 - Vcc - Input Voltage 5V
6 - Vcc - Input Voltage 5V
7 - Vcc - Input Voltage 5V
8 - AGND - Analog Ground
9 - EXTRSTZ - External Reset
10 - AGND - Analog Ground
11 - AGND - Analog Ground
12 - USB D- - USB Data-
13 - USB D+ - USB Data+
14 - AGND - Analog Ground
15 - AGND - Analog Ground

Note that there was no information regarding what kind of the memory card this relates to.





Blue Ray Drive (Drive controller left >right)

1 - RST - Reset
2 - GND - Ground
3 - DD7 - Data 7
4 - DD8 - Data 8
5 - DD6 - Data 6
6 - DD9 - Data 9
7 - DD5 - Data 5
8 - DD10 - Data 10
9 - DD4 - Data 4
10 - DD11 - Data 11
11 - DD3 - Data 3
12 - DD12 - Data 12
13 - DD2 - Data 2
14 - DD13 - Data 13
15 - DD1 - Data 1
16 - DD14 - Data 14
17 - DD0 - Data 0
18 - DD15 - Data 15
19 - GND - Ground
20 - DMARQ - DMA Request
21 - GND - Ground
22 - DIOW - Write Strobe
23 - GND - Ground
24 - DIOR - Read Strobe
25 - GND - Ground
26 - IORDY - I/O Ready
27 - SPSYNC/CSEL - Spindle Sync/Cable Select
28 - DMACK - DMA Acknowledge
29 - GND - Ground
30 - INTRQ - Interrupt Request
31 - IOCS16 - IO ChipSelect 16
32 - DA1 - Address 1
33 - PDIAG - Passed Diagnostics
34 - DA0 - Address 0
35 - DA2 - Address 2
36 - IDE_CS0 - 1F0-1F7
37 - IDE_CS1 - 3F6-3F7
38 - GND - Ground
39 - TP1 - Test Point 1
40 - TP2 - Test Point 2
41 - TP3 - Test Point 3
42 - GND - Ground
43 - UNK - Unknown
44 - UNK - Unknown
45 - UNK - Unknown
46 - UNK - Unknown
47 - UNK - Unknown
48 - UNK - Unknown
49 - UNK - Unknown
50 - LED - LED
51 - GND - Ground
52 - CLKSEN - CLOCK SENSOR
53 - Clksen - CLOCK SENSOR
54 - Dins - disc insert
55 - S_IN - Slot SENSOR check
56 - Eject - Button Eject
57 - DS - DISC PRESENT IN SLOT
58 - DD IN - DISC PRESENT DRIVER
59 - GND - Ground
60 - 3.3VCC - 3.3V

Of course the term unknown is not a signal name.
However it does imply that the actual signal is not identified.





Composite Video (left > right)
Refer to Composite Video Definition
1 - AGND - Analog Audio Ground
2 - AUDR - Audio Right
3 - VGND - Video Ground
4 - AUDL - Audio Left
5 - VIDY - Svideo Y
6 - COMRGBS - Composite Video/RGB Composite Sync
7 - VIDC - Svideo C
8 - GND - Ground
9 - RGBB - Blue
10 - VCC - 5V
11 - RGBR - Red
12 - RGBG - Green

(Green does not carry Horizontail/Vertical syn)
Check pins 3 and 4, may be swapped



HDMI( MOBO right > left)
Refer to the HDMI Definition
1 - TMDS Data 2+
2 - TMDS Data 2 Sheild
3 - TMDS Data 2-
4 - TMDS Data 1+
5 - TMDS Data 1 Shield
6 - TMDS Data 1-
7 - TMDS Data 0+
8 - TMDS Data 0 Shield
9 - TMDS Data 0-
10 - TMDS Clock+
11 - TMDS Clock Shield
12 - TMDS Clock-
13 - CEC
14 - No Connect
15 - DDC Clock
16 - DDC Data
17 - Ground
18 - +5V VCC
19 - Hot Plug Detect
20 - Shell

Also refer to the page that covers TMDS.

This information has not been check for accuracy, or if these are the correct I/O or all the possible connections.
This page does not meet the standards set by any of the other pages, but is listed for informational purposes.


PC motherboard
Home

Distributor rolodex Electronic Components Electronic Equipment EDA CDROM Software Engineering Standards, BOB card Cabled Computer Bus Electronic Engineering Design Table Conversion DB9-to-DB25.
DistributorsComponents Equipment Software Standards Buses Design Reference

Modified 9/13/15
Copyright © 1998 - 2016 All rights reserved Larry Davis